How to Fix Bootloop Error in Pangu Jailbreak IOS 7.1

Yesterday we covered an article on how to jailbreak IOS 7.1 using Pangu windows tool. Though this method worked for most of the people but there were few who reported bootloop error. Most of the users who tried out jailbreak IOS 7.1 by pangu faced no issue but if you are one of those people facing bootloop error then here’s a simple trick which will help you in getting rid of the error.Jailbreak IOS 7.1

Fix jailbreak IOS 7.1 Bootloop error:

Well, the solution for bootloop error seems quite weird but it has worked for many users out there and will definitely work for you as well. Actually, this issue is caused by the light sensor of your iPhone. If there’s not enough light to be detected by the light sensor then your IOS device will enter into a never ending loop. However, we have a very simple yet working tip. In order to get rid of this bootloop error just take a flashlight point it on the light sensor of your IOS device. Yes, this sounds weird but it works. Basically, your phones enters the loop the moment it is in dark so to ensure that your phone starts normally instead of getting into never ending loop just point a flashlight on the light sensor. This will work great to fix the error of bootloop in jailbreak IOS 7.1.

If you are facing the same issue then try out the above mentioned trick and let us know if it works for you or not?

About admin

Check Also

Welcome to WordPress!

Getting started… Login as admin and get blogging! Refer to the TurnKey WordPress release notes …

Leave a Reply

Your email address will not be published. Required fields are marked *

WordPress Appliance - Powered by TurnKey Linux